Industrial Safety Helmet to IS 2925 : 1984 as per annexure-A Annexure -A Industrial... Tender

Procurement Summary

State : Maharashtra

Summary : Industrial Safety Helmet to IS 2925 : 1984 as per annexure-A Annexure -A Industrial Safety Helmet to IS : 2925 : 1984 It shall be as per IS: 2925-1984, made of high quality virgin HDPE material the de...

Deadline : 22 Nov 2018

Other Information

Notice Type : Tender

TOT Ref.No.: 28406861

Document Ref. No. : 88185159B

Financier : Self Financed

Purchaser Ownership : -

Document Fees : Refer Document

Tender Value : Refer Document

EMD : Refer Document

Purchaser's Detail

Name :Login to see tender_details

Address : Login to see tender_details

Email : Login to see tender_details

Login to see details

Tender Details

Industrial Safety Helmet to IS 2925 : 1984 as per annexure-A Annexure -A Industrial Safety Helmet to IS : 2925 : 1984 It shall be as per IS: 2925-1984, made of high quality virgin HDPE material the design shall be domeshaped. The shell shall design in such a manner to take on clip on accessories viz . Ear defenders, face shield and welding visor etc. A) The Mass of helmet shall be 400 gm plus/minus 10 percent. B) Helmet should have ratchet ( knob) type headband shall be not less than 30mm in width and so designed that adjustment to any size may be readily made should be fitted with anti- concussion tapes secured at least at 6 anchoring points, forming a cradle shall not exceed than 300mm sq. Helmet shall be tested and approved by BIS 2925-1984 and CLI Mumbai/DGMS. Manufacturer should provide warranty certificate each helmet shall be legibly and indelibly marked with the following information 1) Manufacturers name or trade name, 2) ISI Mark, 3)As per Annexure Workshop/C. Rly logo ( Screen printed) on the front of helmet, C) It should withstand the performance test such as heat resistance, shock absorption resistance, penetration resistance, electrical resistance, ( leakage current shall not allow in excess of 3 mA) D) It should have a chain strap permanently attached to the shell with fastening device to adjust and maintain tension. E) It should have ventilation holes in the shell to permit circulation of air inside the helmet. the diameter of holes shall not exceed 6mm nor the edges of adjacent holes closer than 15mm. the minimum no. of holes on each side shall be not less than 3 and total aggregate area of holes. F) Size of helmet shall be of 530mm to 620mm+/- 10mm as per IS 2925:1984 Note : 1 ) White Color of helmet-15 Nos., 2) lemon Yellow color-10 Nos, 3) Yellow color-10 Nos, 4) Blue color-10 Nos., 5) Brown color-270 Nos, 6) Cray color-10 Nos. 7) Orange color- 10 Nos. Total Qty - 335 Nos.
Tender Doc. Cost (INR) : 0.00
Earnest Money (INR) : 0.00
Tender Closing Date Time : 22/11/2018 11:30
Tender Type : Open - Indigenous
Contract Category : Expenditure
Evaluation Criteria : Itemwise/Consigneewise
Bidding System : Single Bid System
Pre-Bid Conference Required : No
Pre-Bid Conference Date Time : Not Applicable
Tendering Section : 88
Inspection Agency : CONSIGNEE
Publishing Date / Time : 13/11/2018 15:48
Procure From Approved Sources : No
Approving Agency : Not Applicable

Documents

 Tender Notice