Renovation and Electrical Installation Tender in Namibia - 67825148
Tender notice from Namibia, published on 17 Jun 2022.
Executive Summary
The MINISTRY OF HEALTH AND SOCIAL SERVICES has issued a Tender notice for the procurement of a Renovation and Electrical Installation for Oranjemund State Hospital in the Namibia. This Tender notice was published on 17 Jun 2022 and is scheduled to close on 01 Jul 2022, with an estimated Tender value of Refer Document.
Interested bidders can access detailed Tender information, eligibility criteria, and complete bidding documents by referencing TOT Ref No. 67825148, while the tender notice number is and Register on the platform.
Key facts
Summary
Renovation and Electrical Installation for Oranjemund State Hospital
Quotation are invited for Renovation and Electrical Installation for Oranjemund State Hospital- Kharas Region. Item code Description Qty UOM 1. Taking down and removing ceilings, etc.
Soft board or gypsum board ceilings in isolated panels 7 2m2 Each
2. Taking out and removing doors, windows, frames, etc.(alterations to openings and /or building up openings where applicable
Timber single or double door and timber door frame exceeding 2.5m2 and not exceeding 5m2in area 2.0 each
3. Taking out and removing taps and mixtures
Sink or bath mixture 2.0 each
4. Brickwork in 7MPa cement bricks in class 11 mortar in building up openings, including cutting toothings and bonding new to existing
Half brick walls 1.94 m2 Each
5. Breaking out for and forming openings through brick walls for new door frames and windows including making good plaster on
From opening through one brick wall pressed steel door frame not exceeding 2.5m2 and make good plaster around both sides 1.0 each
6. One coat internal compo plaster steel trowelled smooth
Hack of internal plaster in small isolated patches and replastcr to match existing 5.0 m2 Each
7. Rc-fixing of existing sanitary fittings in new position(removal of sanitary fittings elsewhere measured
Stainless steel single or double bowl sink and drainer unit 1.0 Each
8. Clean down and prepare and one coat Acrylic PVA Paint
On internal smooth plastered walls and columns 5.0 m2 Each
9. Excavation in earth not exceeding lm deep
Trenches and holes 4.0 m3 Each
10. Earth filling obtained from excavations and\or prescribed stock piles on site compacted to 93%Mod AASHTO density
Backfilling to trenches, holes, etc. 2.5 m3 Each
11. 20MPa\19mm concrete
Surface beds, aprons, pavings, ramps, etc. cast in panels 4.0 m5 Each
12. Brickwork of 7MPa cement bricks in class II mortar
Half brick wall 27.08 m2 Each
One brick wall 3.0 m2 m2
13. Wrot Mcranti
69x102mm Rebated door frame to suit 40mm door size 813x2032mm high countersunk plugged, screwed and pelleted to wall 13.0 each
14. 44mm Solid laminated flush doors with hardwood veneer on both sides and concealed edge strips
Door size 813 x 2032mm high 14.0 each
15. VVrot hardwood sliding doors with frames with a linseed oil-based transit stabilizing sealer and a seven year guarantee fixed in
Sliding door with frame type SSDP 1.8 size 1800x2140mm high (2.083m2 glass area) 1. each
Euro profile single cylinder lock with Euro profile lock case and brass forend 10.0 each
18. Door closes and floor springs work
‘Union Gower- lever furniture (pair) with bathroom/wc indicator 12.0 Sets
19. Vertical louvred sun drapes compromising natural anodised aluminium top rail, 120mm wide type F13 colour group 5 louvre
White powder coated single aluminium oval regular duty curtain track with accessories complete fixed to timber pelmets 200.0m Each
20. Natural anodised aluminium top-hung projected-out windows glazed with and including 4mm clear float g|ass
Extra for glazing with 4mm obscure glass in lieu of 4mm clear float glass (measured across the full window area) 7.2 m2 Each
21. Walls
Take delivery of, transport to the site, store, protect and lay ceramic tiles fixed with and including adhesive to plastered 25.0 m2 Each
22. Take delivery of, transport to the site, store protect and lay mazita or natural stone floor tiles of differing sizes fixed and
Floor patterns 20.0 m2 Each
23. Take delivery of, transport to the site, store, protect and lay mazita or natural stone floor tiles of differing sizes fixed with and Skirting 100mm high 10.0m Each
24. White vitreous china or glazed fireclay
Double end bowl inset sink and drainer unit size 1200x500mm 1.0 each
25. Polyethylene, duranite, etc.
Basin size 560x400mm with two tap holes to walls with and including semi-concealed cast iron brackets 32.0 each
26. Porcelain enamelled steel baths
9 Litre high-level duranite w.c cistern complete with flusing mechanism, flush lever and flush pipe 5.0 each
27. Chromium plated brass
Bath size 1700x700mm with adjustable feet, anti-slip finish and chrome handles 2.0 each
28. Vulcathene
40mm Bath or sink waste union with vulcanite plug and chromium plated chain and stay 40.0 each
29. Chromium plated brass
40mm Bottle trap including tailpipe and wall flanged 40.0 each
30. Water meters of semi-positive rotary piston type with flanged connections
20mm Vacuum breaker 4.0 each
31. Water meters of semi-positive rotatory piston type with flanked connections
20mm Expansion relief valve (200kPa) 4.0 each
20mm ‘Masterflo- 200KPa pressure reducing valve with strainer and integral no-retum valve 4.0 each
32. Chromium plated brass medical taps and mixers
15mm Angel regulating valve only 80.0 each
15mm Angle regulating valve with stainless steel braided connector pipe 315mm girth with chromium plated connections 80.0 each
15mm Toilet bib tap 10.0 each
15mm Single tap hole sink mixer with swivel outlet and angle regulating valves 1.0 each
20mm Wall Type bath mixer 2.0 each
15mm Shower rose 85mm diameter 5.0 each
33. Special valves and fittings
15mm Elbow action wall type medical mixer with swivel outlet 32.0 each
34. Water heaters
200 litre Geyser for horizontal or vertical installation 4.0 each
35. Extra over HDPE pipes for the following compression fittings
25mm Pipes laid in ground trenches 100m Each
36. Class 9 uPVC water pipes and Fittings including all straight joints and connectors laid in ground in tenches not less 600mm
25mm fittings 20.0 each
37. Fire appliances work
40mm Pipes laid in ground in trench 60.0m Each
110mm Pipes laid in ground in trench 35.0m Each
38. Class 12 uPVC water pipes and fittings including all straight joints and connectors laid in ground in tenches not less 600mm
40mm Socket adapter coupling 20.0 each
110mm Socket adapter coupling 8.0 each
40mm Straight reducing piece 20.0 each
110mm Straight reducing piece 8.0 each
40mm Elbows 20.0 each
110mm Elbow 8.0 each
40mm Equal tee 20.00 each
39. Extra over class 0 copper pipes for brass capillary fittings
15mm Pipe fixed or chased into walls 40.0m Each
22mm Pipe fixed or chased into walls 40.00m Each
40. Galvanised mild steel medium grade pipes including all straight joints and connectors
‘Everyway- hose reel complete with 30m rubber hose, chromium plated stopcock, shut-off nozzle and wall bracket 2.0 each
44. Underground twin-wall uPVC structured wall pipes laid in ground, including excavations, backfilling, etc. and all straight joints
110mm Access bend with vent horn 5.0 each
45. UPVC Gulleys with gullley head and grating encased in concrete
110mm Rodding eye 3.0 each
46. Inspection chambers
110mm Gulley P-trap not exceeding Im deep 3.0 each
47. White powder coated aluminium
Flagpole 7500mm high overall comprising: 76mm external diameter x 2.8mm thick lower post 4000mm long four times holed 2.0 each
48. Total Value of building items
49. Escalation at 0.12
50. Sub Total:
51. District Allowance 8%
52. Sub Total:
53. Preliminaries Allowance 8% A B C D
Item code Description Qty UOM Unit Price NS (Excl VAT Total price NS Excl. VAT)
1. Plasticised polyvinyl chloride (UPVC) sleeve piping including short lengths and jointing, laid in trench (trench backfilling) (Electrical Installation work)
32mm Diameter x 300mm long complete with connectors at both ends 10.0 No
Initial:
15
2. Sundries (work)
110mm Diameter long radius bend 10.0 No
3. Silicone insulated wires asbestos
4mm2 20, 0m
4. Underground cable PVC SWA PVC installed
4mm2 10.0m
5. Metal Cable terminations
4mm2 Surfix cable 2 core + Earth 30.0m
6. Cover only double outlet lOOmni x 100mm
Double outlet 100 x 100mm complete with cover 8.0 No
7. Single pole
As above, but surface mounted including enclosure 4.0 No
15-25 Amp 1.0 No
8. Double pole
30-40 Amp 4.0 No
9. Total Value of Building Items:
10. Value of Scheduled Items:
11. Escalation at 0.12
12. Sub Total:
14. District Allowance 8%
16. Preliminary Allow ance 8% For enquiries, please contact the following people:
1. Technical enquiries: Mr. N. Hilukilwa- Tel: 061- 2032744
2. Administrative enquiries: Ms. M.P. Epafras- Tel: 061- 2032255 Sealing and Marking of Quotations
Quotations should be sealed in a single envelope, clearly marked with the Procurement Reference Number, addressed to the Ministry, with the Bidder's name and contact information at the back of the envelope.
Submission of Quotations
Quotations should be deposited in the Quotation/Bid Box located at The Ministry of Health and Social Services - Finance and Procurement building, Procurement Management Unit (Tender Office), Harvey Street, Windhoek-West, not later than 01 July 2022, Time: 11H00.
Opening of Quotations
Quotations will be opened internally by the Ministry immediately after the closing time referred to in instruction 7 above. A record of the Quotation Opening stating the name of the bidders, the amount quoted, will be posted on the website of the Ministry and available to any bidder on request within th
The bid deadline for Renovation and Electrical Installation for Oranjemund State Hospital was 01 Jul 2022. Bidding is closed.
This tender has been issued by MINISTRY OF HEALTH AND SOCIAL SERVICES in Namibia.
The tender value is not disclosed; please refer to the tender document. EMD / bid security details are provided in the tender document.
This tender is Self Financed
The tender notice and related documents are listed in the Documents section above. Select a document to view or download it. Please log in or register to access the documents. If you cannot find additional documents in the Documents section, please log in to your account and Send Document Request from your account section.
The TendersOnTime reference is 67825148. The purchaser document reference is not provided in the notice.
Browse other tenders from Namibia or search by relevant keywords and CPV classification.