Fiberglass Tank Stand, Oty: 10 Tender in Oman - 122622424

Procurement Summary

Country: Oman

Summary: Fiberglass Tank Stand, Oty: 10

Deadline: 21 Jul 2025

Posting Date: 14 Jul 2025

Other Information

Notice Type: Tender

TOT Ref.No.: 122622424

Document Ref. No.: 7038/25/0041

Competition: ICB

Financier: Self Financed

Purchaser Ownership: Public

Tender Value: Refer Document

Purchaser's Detail

Name: Login to see tender_details

Address: Login to see tender_details

Email: Login to see tender_details

Login to see details

Tender Details

Category : Consumables
SQU Product Code : CONRESCEN2025
Description : Fiberglass Tank Stand
Quantity : 10
Remark : Configuration: Single integrated stand supporting 1 row of 3 tanks.Orientation: Tank stands are placed side by side in rows, each row has two stands (2 x 3 = 6 tanks).Tank Spacing: Minimum 10 cm between tanks for access and airflowMain Material: Fiberglass Reinforced Plastic (FRP). Resin Type: Isophthalic polyester or vinyl ester resin for chemical and moisture resistance.Surface Finish: Marine-grade gelcoat (light blue or light gray), smooth and easy to clean. The edges should be round. Dimensions: Total length = 220 cm, Stand height from floor = 50 cm, Total width = 65-70 cm (enough to hold one row of tanks plus the pipe holder on the inner end of the tank stand. Tank stand top deck: The top deck of the tank stand should have enough area for proper load distribution and prevent stress concentrations on small contact points of the tank. At the same time, it should allow for enough space for the drainage pipe. Example of the design: fiberglass sheet reinforced with ribs underneath. Rubber or Foam sheet: placed under the tanks as a cushioning layer. Load capacity: not less than 300 kg per tank position (900 kg total). Each tank stand needs to have a total of 8 stand legs (4 on each side). These legs are reinforced by internal ribbing and have spaces for drainage pipes with access space beneath each tank for drain fittings (bulkhead + pipe).Air and Water Pipe Holder: Holder height above the tank stand = 50 cm. It is a vertical fiberglass holder located on the inside of the tank stand, anchored directly into the base stand for structural stability. Height (above tank stand) = ~80-90 cm. This rack will hold and support the airline and water inlet PVC pipes.
Invitation Date : 14/07/2025
Last Date Of Submission : 21/07/2025

Documents

 Tender Notice