Robline Ocean Sts Tender in USA - 151719443

Procurement Summary

Country: USA

Summary: Robline Ocean Sts

Deadline: 29 Oct 2026

Posting Date: 30 Oct 2026

Other Information

Notice Type: Tender

TOT Ref.No.: 151719443

Document Ref. No.: N6660427Q0041

Competition: ICB

Financier: Self Financed

Purchaser Ownership: Public

Tender Value: Refer Document

Purchaser's Detail

Name: Login to see tender_details

Address: Login to see tender_details

Email: Login to see tender_detailsLogin to see details

Tender Details

Amendment 0002
The purpose of this amendment is to extend the respose period for this opportunity and to provide the following responses to Industry questions.
Question 1: The combined synopsis identifies “Robline (Ocean) STS” 8 mm rope as part 7155408. Robline-s published catalog lists 7152800 for the 8 mm Ocean STS (Dyneema) variant and 7155408 for the 8 mm Robtec STS (HMPE) variant; both show 9, 430 daN breaking load and about 47 g/m linear density.
Answer 1: The required part number is 7155408. The number listed below (7152800) is an old part number and is now obsolete.
Question 2: Please confirm whether the required product is the Robtec STS 7155408 or Ocean STS 7152800, and which product name must appear on the manufacturer CoC and test reports. The notice also specifies elongation no greater than 0.19% at 94.3 kN, which is the stated breaking-strength threshold. Please confirm the intended test load and method for that elongation figure so we can obtain matching certified data.
Answer 2: The specified elongation no greater than 0.19% at 94.3 kN corresponds to the ultimate breaking strength. Elongation is measured at the point of failure during a standard "pull to break" (destructive) test. The manufacturer's standard destructive testing method (measuring elongation at the ultimate breaking strength threshold) is fully acceptable to the Government.
Amendment 0001
The purpose of this amendment to is to provide the following response to Industry question:
Question 1: Please confirm the intended elongation test requirement and test load for Robline P/N 7155408. The solicitation states elongation ≤0.1% at 94.3 kN, while 94.3 kN is the published average breaking-load value. Please advise the acceptable manufacturer test method and documentation required for technical acceptability.
Answer 1: As indicated in the RFQ, the elongation requirement is ≤0.19% at 94.3 kN (not ≤0.1% as stated in the question).
See basis of award in this RFQ f...

Documents

 Tender Notice