Request for the Supply and Install of an Air Tender - 128561846

Procurement Summary

Country: Ireland

Summary: Request for Tender for the Supply and Install of an Air Compressor Heat Recovery System at Smartply Europe Dac ‘25

Deadline: 10 Nov 2025

Posting Date: 21 Oct 2025

Other Information

Notice Type: Tender

TOT Ref.No.: 128561846

Document Ref. No.:

Competition: ICB

Financier: Self Financed

Purchaser Ownership: Public

Tender Value: Refer Document

CPV Classification

71314310 - Heating engineering services for buildings
44622100 - Heat-recovery equipment
42511110 - Heat pumps
71334000 - Mechanical and electrical engineering services
50721000 - Commissioning of heating installations
45232141 - Heating works

Purchaser's Detail

Name: Login to see tender_details

Address: Login to see tender_details

Email: Login to see tender_detailsLogin to see details

Tender Details

Smartply Europe DAC are seeking suitably qualified engineering companies to supply and install an upgraded air compressor heat recovery system at our site at Belview Port Waterford. This system is to improve compressor operating conditions and provide a sustainable hot water source for the SAP cleaning process. The new system will repurpose parts of the existing pipework and buffer tanks but replace unfit components with new equipment as per the design and drawings attached. There are two existing buffer tanks in place with existing pipework. Some of the existing pipework leads over to an existing calorifier. The works includes: • Calorifier Replacement: Remove the existing 800 L stainless steel cylinder and install a new 1, 200 L stainless steel calorifier (New calorifier will be purchased by Smartply and onsite for installation). Adjust existing pipework to accommodate the 200 mm taller unit, the red line below roughly the height of the new unit • Break Tank and Booster System: Supply and install a 1, 000 L plastic break tank complete with ball cock above the calorifier on the well water circuit. Supply and install a Wilo Helix booster pump set to pressurise the calorifier with well water. Install two 100 L PN16 pressure vessels on this circuit. • Heat Dump System: Supply and install a heat dump system consisting of two LPHW unit heaters, a circulating pump, and associated insulated pipework and fittings adjacent to the existing buffer tanks. We plan on using this wasted heat to heat our resin. We plan on putting the two fans at a height, shown in the red box below, in the same room as the buffer tanks as this is not an Atex zone. These will reclaim waste heat to warm resin pumps and pipework. The resin is stored in a room on the opposite side of the wall shown, which may be classified as an ATEX zone. Our plan is to install the fans on the non-ATEX side of the wall and run ducting through the wall, so the warm air emerges behind the resin tanks. This heated air wil...
Procedure : Open

Publication Date : 10/11/2025

Deadline : 10/11/2025 15:00:00

Documents

 Tender Notice