Procurement Summary
Country : USA
Summary : Radio Frequency (Rf) Anechoic Absorber Chamber Upgrade
Deadline : 14 May 2024
Other Information
Notice Type : Tender
TOT Ref.No.: 100629036
Document Ref. No. : N6893624Q0096
Competition : ICB
Financier : Self Financed
Purchaser Ownership : Public
Tender Value : Refer Document
Purchaser's Detail
Purchaser : DEPT OF DEFENSE
Contracting Office Address : CHINA LAKE, CA 93555-6018
Primary Point of Contact : Brandi Smith
brandi.c.smith6.civ@us.navy.mil
Phone Number 7606080281
Secondary Point of Contact : Scott Hansen
scott.c.hansen.civ@us.navy.mil
Phone Number 7607934451
USA
Email :brandi.c.smith6.civ@us.navy.mil
Tender Details
Description
The Naval Air Warfare Center Weapons Division, China Lake, CA, intends to procure for the removal and replacement of an existing RF Anechoic Absorber Chamber-s Radiation-Absorbent Material (RAM). Dimension of RF Anechoic Absorber Chamber is 31-W x 28-L x 29-H. Contractor shall supply all the necessary materials including freight, equipment, labor, disposal, and supervision to install the new RAM, excluding any Construction as defined in FAR Subpart 2.101 and FAR Part 36. Requirements will include:
The contractor shall remove existing RAM on walls, ceiling, and floor and place into dumpsters supplied by contractor, and properly disposed. The existing RAM shall be removed while minimizing damage to the chambers shielded surface.
The contractor shall clean and prepare walls and ceiling surfaces to maximize adhesion of new RAM. Minor cosmetic repairs to surface and/or shielding shall be performed, as necessary.
The contractor shall install full coverage of new RAM on all four walls and ceiling using high-strength adhesive. New RAM shall include 12-inch pyramidal RAM on the ceiling and 18-inch pyramidal RAM on the walls. All corners will be treated with corner block RAM. Special attention shall be given during the installation process to ensure the match between adjacent pieces has minimal gaps or overcrowding. Periodic inspections shall be performed by perpendicularly illuminating the surface of the darkened chamber with a collimated light, making sure each are properly aligned prior to adhesive fully curing. Any uncharacteristic gaps or “shiners” shall be adjusted or stuffed to prevent unwanted reflections.
The contractor shall clean any debris prior to installation of new 18-inch pyramidal RAM on floor. The floor pieces shall be laid loose and not glued down to enable them to be removable/relocatable when needed. Floor absorber must be RF absorbent rubber coated.
The contractor shall build an open walkway with entry steps ...
Active Contract Opportunity Notice ID N6893624Q0096 Related Notice Department/Ind. Agency DEPT OF DEFENSE Sub-tier DEPT OF THE NAVY Major Command NAVAIR Sub Command NAVAIR NAWC WD Office NAVAL AIR WARFARE CENTER
General Information
Contract Opportunity Type: Sources Sought (Original)
All Dates/Times are: (UTC-07:00) PACIFIC STANDARD TIME, LOS ANGELES, USA
Original Published Date: Apr 29, 2024 09:32 am PDT
Original Response Date: May 14, 2024 05:00 pm PDT
Inactive Policy: Manual
Original Inactive Date: May 13, 2025
Initiative: None
Classification
Original Set Aside:
Product Service Code: 6625 - ELECTRICAL AND ELECTRONIC PROPERTIES MEASURING AND TESTING INSTRUMENTS
NAICS Code: 334519 - Other Measuring and Controlling Device Manufacturing
Place of Performance:
Documents
Tender Notice