DEPT OF DEFENSE has floated a tender for Armaments Airline and Power Outlet. The project location is USA and the tender is closing on 13 May 2024. The tender notice number is FA480024MP0001, while the TOT Ref Number is 101019820. Bidders can have further information about the Tender and can request the complete Tender document by Registering on the site.

Expired Tender

Procurement Summary

Country : USA

Summary : Armaments Airline and Power Outlet

Deadline : 13 May 2024

Other Information

Notice Type : Tender

TOT Ref.No.: 101019820

Document Ref. No. : FA480024MP0001

Competition : ICB

Financier : Self Financed

Purchaser Ownership : Public

Tender Value : Refer Document

Purchaser's Detail

Purchaser : DEPT OF DEFENSE
Contracting Office Address : LANGLEY AFB, VA 23665
Primary Point of Contact : Mandisa Peters
mandisa.peters.1@us.af.mil
Phone Number 7577647427

Secondary Point of Contact : Mr Corey Powell
corey.powell.1@us.af.mil
Phone Number 7572254010
USA
Email :mandisa.peters.1@us.af.mil

Tender Details

Description

Shut off air compressor and LOTO circuit

- Bleed all air pressure off piping

- Cut in a 2”x2”x3/4” copper press tee, install ball valve in the ceiling for the parts washers

- Cut in a 2”x2”x1” copper press tee, install ball valve in the ceiling for the sand blaster

- Take LOTO off the air compressor circuit, and turn air compressor back on

- Leak check the new fittings that where installed

- Fabricate support hangers in the ceiling for both air line runs

- Fabricate support hangers coming down the wall for both air line runs

- Run out ¾” copper pipe from new ball valve down to parts washer

- Install ball valve, air regulator, and a hose that will connect to the parts washer

- Drill hole through the block wall for the sand blaster air line

- Run out 1” copper pipe from new ball valve, through the block wall and down to sand blaster

- Install ball valve and tee fitting, run 2 hoses off the tee to each connection on the sand blaster

- Seal up hole around the 1” copper pipe where it goes through the block wall

- Drill an additional hole in the same wall for the electrical conduit

- Run out conduit from panel F751_N_1PPC out through the wall and down to sand blaster

- Install a 20amp receptacle for the sand blaster

- Seal up hole around the conduit where it goes through the block wall

- Open air valves to each machine and verify nothing is leaking

- Turn power on to the receptacle and check for proper voltage
Active Contract Opportunity Notice ID FA480024MP0001 Related Notice Department/Ind. Agency DEPT OF DEFENSE Sub-tier DEPT OF THE AIR FORCE Major Command AIR COMBAT COMMAND Office FA4800 633 CONS PKP
General Information
Contract Opportunity Type: Solicitation (Original)
All Dates/Times are: (UTC-04:00) EASTERN STANDARD TIME, NEW YORK, USA
Original Published Date: May 08, 2024 01:34 pm EDT
Original Date Offers Due: May 13, 2024 02:00 pm EDT
Inactive Policy: 15 days after date offers due
Original Inactive Date: May 28, 2024
Initiative: None

Classification
Original Set Aside: Total Small Business Set-Aside (FAR 19.5)
Product Service Code: 3433 - GAS WELDING, HEAT CUTTING, AND METALIZING EQUIPMENT
NAICS Code: 238220 - Plumbing, Heating, and Air-Conditioning Contractors

Place of Performance: Langley AFB, VA 23665 USA

Documents

 Tender Notice

Statement-of-Requirement.pdf